Altered Pizza Board~Wall Hanger

Supply List:
1 ~ 12 inch round pizza cardboard
Spray on Adhesive
Scraps or sheets of pattern paper
1 yard of ribbon
embellishments of your choice
photo {s}
scissors
hole punch (whatever you have on hand)
ink (opitional)

Step #1: Collect you supplies. Don't forget the ribbon, cut you yard of ribbon in half. Not shown in photo's. Take the spray adhesive and give your pizzia cardboard a good coat. Stick to pp. Let dry for at least 3 minutes. Then cut your circle out around your pizza board.



Step #2: I inked my edges before starting this step. Take your hole punch and at 10:00 and 2:00 punch three holes at each area. Here you will take your yard of ribbon and poke it through the bottom hole and tie a knot.


Step #3: Weave your ribbon down through the second (middle) hole.


Step #4 - FRONT SIDE VIEW: Then back up through the third hole and down through the second hole again. Do this for both sides. Repeat steps 2-4 for the other side.


Step #5 - BACK SIDE VIEW: Tie the ends of your ribbon together to make you hanger. Like shown. (Note: you don't have to cut your ribbon to tie the knot you can leave it as a whole piece.)


Step #6: Decorate to you liking.